Magnetic omnidirectional antenna with high efficiency for all GPRS / EDGE / UMTS and HSDPA telephony systems operating in the 850MHZ -2170 MHz band. Thanks to the extremely high signal gain, the antenna perfectly solves the problem of low coverage level. Equipped with an integrated 5-meter cable, terminated with a universal connector for Huawei modems. It works very well wherever there is a need for mobile solutions. The antenna has 11dBi amplification allowing to obtain a stable GPRS / EDGE connection in most situations. The magnetic base allows for quick and easy installation of the antenna on virtually any flat metal surface.

3G/4G Antenn 11.9Db (Huawei CRC9)

13 dBi high gain magnetic antenna. Consists of three elements: 13dbi emitter, 8m low loss RG-58 cable, 80mm base with strong magnet.
It gives excellent results in a place where the GSM signal is very weak. The antenna provides a stable EDGE signal.
The antenna is designed to work in GSM/GPRS/EDGE systems.

Antenn 4G LTE (SMA - 5m). 12dB

Antenn 7Dbi for 4G LTE modem (2XSMA connectors)-3m cord 

Antenn for 4G LTE modem(2 X TS9)-3m cord

Antenn for 4G LTE modem (2XSMA connectors)-3m cord

PS ANTENNA L4G MIMO 10m SMA. A set of two multi-band antennas for cellular data transmission.

L4G MIMO is designed to operate on different transmit and receive channels. Works in all existing and future networks in Europe. It is a system of two directional external antennas with opposite polarization, designed for data transmission in cellular networks in the DC (Dual Carrier) system. Two X-pol antennas ensure perfect separation of MIMO transmission channels. Thus, the assembly reduces the error rate in the signal and raises the data transfer rate to a higher level. It perfectly solves the problem when the signal is too weak for the correct operation of the modem or repeater. The modern design, logarithmically periodic, gives high gain over a very wide transmission frequency range. Factory prepared for direct pole mounting. Requires no experience from the installer. It is enough to install the antenna on the mast, point it at the transmitter, connect the cables to the modem in order to improve the signal level and significantly increase the Internet speed. 

PS ANTENNA L4G MIMO 15m SMA. A set of two multi-band antennas for cellular data transmission.

L4G MIMO is designed to operate on different transmit and receive channels. Works in all existing and future networks in Europe. It is a system of two directional external antennas with opposite polarization, designed for data transmission in cellular networks in the DC (Dual Carrier) system. Two X-pol antennas ensure perfect separation of MIMO transmission channels. Thus, the assembly reduces the error rate in the signal and raises the data transfer rate to a higher level. It perfectly solves the problem when the signal is too weak for the correct operation of the modem or repeater. The modern design, logarithmically periodic, gives high gain over a very wide transmission frequency range. Factory prepared for direct pole mounting. Requires no experience from the installer. It is enough to install the antenna on the mast, point it at the transmitter, connect the cables to the modem in order to improve the signal level and significantly increase the Internet speed. 

PS ANTENNA L4G MIMO 5M SMA. A set of two multi-band antennas for cellular data transmission.

L4G MIMO is designed to operate on different transmit and receive channels. Works in all existing and future networks in Europe. It is a system of two directional external antennas with opposite polarization, designed for data transmission in cellular networks in the DC (Dual Carrier) system. Two X-pol antennas ensure perfect separation of MIMO transmission channels. Thus, the assembly reduces the error rate in the signal and raises the data transfer rate to a higher level. It perfectly solves the problem when the signal is too weak for the correct operation of the modem or repeater. The modern design, logarithmically periodic, gives high gain over a very wide transmission frequency range. Factory prepared for direct pole mounting. Requires no experience from the installer. It is enough to install the antenna on the mast, point it at the transmitter, connect the cables to the modem in order to improve the signal level and significantly increase the Internet speed. 

PS ANTENNA L4G MIMO 5M SMA. A set of two multi-band antennas for cellular data transmission.

L4G MIMO is designed to operate on different transmit and receive channels. Works in all existing and future networks in Europe. It is a system of two directional external antennas with opposite polarization, designed for data transmission in cellular networks in the DC (Dual Carrier) system. Two X-pol antennas ensure perfect separation of MIMO transmission channels. Thus, the assembly reduces the error rate in the signal and raises the data transfer rate to a higher level. It perfectly solves the problem when the signal is too weak for the correct operation of the modem or repeater. The modern design, logarithmically periodic, gives high gain over a very wide transmission frequency range. Factory prepared for direct pole mounting. Requires no experience from the installer. It is enough to install the antenna on the mast, point it at the transmitter, connect the cables to the modem in order to improve the signal level and significantly increase the Internet speed. 

H4G antenna 2 x 15 dBi LTE / UMTS 1,8-2,1GHz

H4G antenna, antenna gain 2 x 15 dBi. It is an external, highly directional antenna designed for LTE, UMTS, HSPA + cellular systems operating in the 1.8-2.2 GHz band. It perfectly solves the problem when the 4G / 3G signal is too weak for the correct operation of the modem or repeater. It is enough to attach the antenna to the modem to improve the signal level and enjoy high-speed Internet.
The special feature of the antenna: the circularly polarized H4G antenna, does not require proper polarization, as is the case with Yagi Uda dipole antennas or panel antennas.
This makes it easier to install the antenna, even by people unfamiliar with technical issues.

H4G antenna 2 x 15 dBi LTE / UMTS 1,8-2,1GHz

H4G antenna, antenna gain 2 x 15 dBi. It is an external, highly directional antenna designed for LTE, UMTS, HSPA + cellular systems operating in the 1.8-2.2 GHz band. It perfectly solves the problem when the 4G / 3G signal is too weak for the correct operation of the modem or repeater. It is enough to attach the antenna to the modem to improve the signal level and enjoy high-speed Internet.
The special feature of the antenna: the circularly polarized H4G antenna, does not require proper polarization, as is the case with Yagi Uda dipole antennas or panel antennas.
This makes it easier to install the antenna, even by people unfamiliar with technical issues.

H4G antenna 2 x 15 dBi LTE / UMTS 1,8-2,1GHz

H4G antenna, antenna gain 2 x 15 dBi. It is an external, highly directional antenna designed for LTE, UMTS, HSPA + cellular systems operating in the 1.8-2.2 GHz band. It perfectly solves the problem when the 4G / 3G signal is too weak for the correct operation of the modem or repeater. It is enough to attach the antenna to the modem to improve the signal level and enjoy high-speed Internet.
The special feature of the antenna: the circularly polarized H4G antenna, does not require proper polarization, as is the case with Yagi Uda dipole antennas or panel antennas.
This makes it easier to install the antenna, even by people unfamiliar with technical issues.

antenna The 4G LTE antenna was created to improve the quality of the Internet at home, in the office and in any other room with Internet access. Our solution offers:
- support for the 4G LTE standard - provides signal speed up to 300 Mb / s,
- double SMA connector - allows you to connect to devices using coaxial cables,
- modern design - thanks to the use of high-quality materials and attention to detail

Micro Sim card Cutter for IPad and IPhone4G

Micro/nano SIM adapter

Nano Sim card Cutter for mobile devices

SMA plug

Baseus Cube gravity car phone holder for mounting in the air outlet.
Thanks to the fastening system with a lock and a strong spring, slide the holder into the ventilation grille.
The phone is secured by gravity, the phone grips with its own weight and the side holders close firmly.
No complicated jaw extension, just place or remove the phone, all with one hand only.
The holder is also equipped with a hinge for turning the phone to the ideal position.

Baseus Mouth Dash Mount Car Holder for Smartphones up to 7"

Ultimate stability! Keep your smartphone in direct-view using the Baseus Mouth car holder! This universal car holder is designed for any device that is up to 8.5cm wide. Mount the Baseus Mouth on the car's dashboard and use your phone as a GPS navigation.

The Baseus Mouth car holder features silicone and anti-slip pads on the clamp, that protect your devices from sliding and scratching. Drive at rough terrains with no worry.

Universal Car holder Baseus SUYL-XP09 (clip suction mount)

Universal Car holder Baseus SUYL-XP09 (clip suction mount)

BOROFONE BH11 sharp air outlet mount in-car smartphone holder 55mm-82mm clamp for 3.5 – 6 inch mobile phones.

BOROFONE BH17 Ice jade in-car phone holder for center console, magnetic, rotatable, foldable

Borofone BH10 magnetic in-car phone holder for air outlet

Borofone BH40 magnetic in-car phone holder for air outlet

Maxpower MXCH-13 magnetic in-car phone holder for air outlet

Gravity phone holder
The whole idea behind this holder is that you slide the smartphone into the wider part of the holder and the pressure force opens the bottom part and clamps the phone. It all attaches to the air vent

Installing the phone holder
The easiest way to install is to place the holder in the air vent. The holder itself simply slides onto the swivel mount, allowing you to position your phone in a comfortable position.

Technical details
distance between clamps: 65-80 mm
material: plastic

Attach your smartphone to the ventilation grille of your vehicle and keep the display available for navigation. Buy a Dudao Ftxs gravity phone holder that will impress at first sight with its slim design. The holder is universal. It has two arms that automatically clamp and firmly hold the smartphone so that it does not fall out even when driving fast.

CA38 Platinum sharp air outlet mount in-car smartphone holder 55mm-82mm clamp for 3.5 – 6 inch mobile phones.

CA50 in-car dashboard phone holder for up to 7 inch mobile phones small body not occupying a place

CA56 Metal armour gravity car holder for air outlet for 3.5-6 inch mobile phones

CA45 magnetic phone holder for car center console and desktop universal rotation

CA70 Pilot in-car holder for car rearview mirror, for mobile phones and tablets up to 6.5 inches

CA94 Polaris, in-car phone holder for air outlet, for 4.5-6.7 inches mobile phones

Attach your smartphone to the ventilation grille of your vehicle and keep the display available for navigation. Buy a Joyroom JR-ZS255 phone holder that will impress at first sight with its slim design. The holder is universal. It has two arms that automatically clamp and firmly hold the smartphone so that it does not fall out even when driving fast.

OBAL:ME GravGripper car mount adapts perfectly to all sizes of mobile phones.
The gravity style is characterized by easy quick phone attachment.
By inserting the phone into the mount, its weight activates the safelock mechanism, securely fixing the phone in place.

The car mount, which is mounted on the windshield or dashboard, allows the phone to be stably positioned within sight and hands of the driver. The telescopic leg allows you to adjust its length. The design of the holder allows you to operate it with one hand.